My Cobalt Flux pad isn't working.
http://mypage.iu.edu/~chawagne/DSCF0011.JPG
http://mypage.iu.edu/~chawagne/DSCF0013.JPG
Two of the panels are not working. I've tried to figure out what is wrong, and for whatever reason, the wire just will not trigger the sensor. They are a little bit frayed, but I don't think that would cause an issue. I'm willing to pay someone if they can fix it. The only thing I can't figure out is how to get inside of the damn thing.
[req] halp with CF pad
Moderator: Moderators
- Amp Divorax
- Heavy
- Posts: 2922
- Joined: Wed Feb 02, 2005 3:34 pm
- Location: Near some arcade place that has the same initials as Drum and Bass
Have you made sure the Control Box is good on all buttons? Some of the older V2 boxes like to pull wacky crap. I know back in the day the Cobalt Flux forums had more information on this, but sadly they are not up anymore.
Memorable 2016 quotes:
Ho wrote:You can break arcade games and I will fix YOU!
- Fluffyumpkins
- Moderator
- Posts: 6592
- Joined: Wed Feb 02, 2005 1:53 pm
Good question. Yes, I've tested it on a working control box. My old control box worked fine for years, but suddenly gave me these problems. Also tested a new control box and had the same problem with the same buttons.Amp Divorax wrote:Have you made sure the Control Box is good on all buttons? Some of the older V2 boxes like to pull wacky crap. I know back in the day the Cobalt Flux forums had more information on this, but sadly they are not up anymore.
- Amp Divorax
- Heavy
- Posts: 2922
- Joined: Wed Feb 02, 2005 3:34 pm
- Location: Near some arcade place that has the same initials as Drum and Bass